※萬向節注意事項：
1調整時不能超過規定的角度15度
2如超過此極限。心軸易磨損或斷裂
3工作時應經常加潤滑油脂
※Note of cardan Joint
1.Do not set the angle to more than the specifled l5 degrees.
2.If the limit is exceeded，the shaft will be easy to wear or break.
3.During work，lubrication should be added frequently.
|
型號 Type |
SU80 |
SU110 |
SU165 |
SU200 |
SU250 |
SU300 |
|
筒夾規格Collet/ 最大鉆孔能力 Max.Drilling Capacity |
D4 |
ER8/5 C5/5 ERll/7 C6/6 ERl6/10 C9/9 ER20/13 C12/12 |
ER8/5 C5/5 ERll/7 C6/6 ERl6/10 C9/9 ER20/13 C12/12 |
ER8/5 C5/5 ERll/7 C6/6 ERl6/10 C9/9 ER20/13 C12/12 |
ER8/5 C5/5 ERll/7 C6/6 ERl6/10 C9/9 ER20/13 C12/12 |
ER8/5 C5/5 ER11/7 C6/6 ERl6/10 C9/9 ER20/13 C12/12 |
|
轉速比 Gear Ratio |
1∶1 |
1∶1 1∶2 |
1∶1 1∶2 |
1∶1 1∶2 |
1∶1 1∶2 |
1∶1 1∶2 |
|
最小距離（二軸間） Lowest Distance(Two Spindle) |
10 |
13(ER8 C5) 18(ER11 C6) 26(ER16 C9) 28(ER20 C12) |
13(ER8 C5) 18(ER11 C6) 26(ER16 C9) 28(ER20 C12) |
13(ER8 C5) 18(ER11 C6) 26(ER16 C9) 28(ER20 C12) |
13(ER8 C5) 18(ER11 C6) 26(ER16 C9) 28(ER20 C12) |
13(ER8 C5) 18(ER11 C6) 26(ER16 C9) 28(ER20 C12) |
|
最大軸心范圍 Max.Range of Centers |
80 |
110 |
165 |
200 |
250 |
300 |
|
軸數Spindle |
2-4 |
2-6 |
2-10 |
4-12 |
4-12 |
4-14 |
掃一掃
QQ咨詢